# 3.6: Wave Equation for a TEM Transmission Line

- Page ID
- 3914

[m0027_Wave_Equations_for_a_Transmission_Line]

Consider a TEM transmission line aligned along the \(z\) axis. The phasor form of the Telegrapher’s Equations (Section [m0079_Telegraphers_Equations]) relate the potential phasor \(\widetilde{V}(z)\) and the current phasor \(\widetilde{I}(z)\) to each other and to the lumped-element model equivalent circuit parameters \(R'\), \(G'\), \(C'\), and \(L'\). These equations are \[-\frac{\partial}{\partial z} \widetilde{V}(z) = \left[ R' + j\omega L' \right]~\widetilde{I}(z) \label{m0027_eTelegraphersEquation1p}\] \[-\frac{\partial}{\partial z} \widetilde{I}(z) = \left[ G' + j\omega C' \right]~\widetilde{V}(z) \label{m0027_eTelegraphersEquation2p}\]

An obstacle to using these equations is that we require both equations to solve for either the potential or the current. In this section, we reduce these equations to a single equation – a *wave equation* – that is more convenient to use and provides some additional physical insight.

We begin by differentiating both sides of Equation [m0027_eTelegraphersEquation1p] with respect to \(z\), yielding: \[-\frac{\partial^2}{\partial z^2} \widetilde{V}(z) = \left[ R' + j\omega L' \right]~\frac{\partial}{\partial z} \widetilde{I}(z)\] Then using Equation [m0027_eTelegraphersEquation2p] to eliminate \(\widetilde{I}(z)\), we obtain \[-\frac{\partial^2}{\partial z^2} \widetilde{V}(z) = -\left[ R' + j\omega L' \right]\left[ G' + j\omega C' \right]~\widetilde{V}(z)\] This equation is normally written as follows: \[\boxed{ \frac{\partial^2}{\partial z^2} \widetilde{V}(z) -\gamma^2~\widetilde{V}(z) =0 } \label{m0027_eWaveEqnV}\] where we have made the substitution: \[\gamma^2 = \left( R' + j\omega L' \right)\left( G' + j\omega C' \right)\] The principal square root of \(\gamma^2\) is known as the *propagation constant*: \[\gamma \triangleq \sqrt{\left( R' + j\omega L' \right)\left( G' + j\omega C' \right)} \label{m0027_egamma}\]

The *propagation constant* \(\gamma\) (units of m\(^{-1}\)) captures the effect of materials, geometry, and frequency in determining the variation in potential and current with distance on a TEM transmission line.

Following essentially the same procedure but beginning with Equation [m0027_eTelegraphersEquation2p], we obtain \[\boxed{ \frac{\partial^2}{\partial z^2} \widetilde{I}(z) -\gamma^2~\widetilde{I}(z) =0 } \label{m0027_eWaveEqnI}\]

Equations [m0027_eWaveEqnV] and [m0027_eWaveEqnI] are the *wave equations* for \(\widetilde{V}(z)\) and \(\widetilde{I}(z)\), respectively.

Note that both \(\widetilde{V}(z)\) and \(\widetilde{I}(z)\) satisfy the *same* linear homogeneous differential equation. This does *not* mean that \(\widetilde{V}(z)\) and \(\widetilde{I}(z)\) are equal. Rather, it means that \(\widetilde{V}(z)\) and \(\widetilde{I}(z)\) can differ by no more than a multiplicative constant. Since \(\widetilde{V}(z)\) is potential and \(\widetilde{I}(z)\) is current, that constant must be an impedance. This impedance is known as the *characteristic impedance* and is determined in Section [m0052_Characteristic_Impedance].

The general solutions to Equations [m0027_eWaveEqnV] and [m0027_eWaveEqnI] are \[\widetilde{V}(z) = V_0^+ e^{-\gamma z} + V_0^- e^{+\gamma z} \label{m0027_eV}\] \[\widetilde{I}(z) = I_0^+ e^{-\gamma z} + I_0^- e^{+\gamma z} \label{m0027_eI}\] where \(V_0^+\), \(V_0^-\), \(I_0^+\), and \(I_0^-\) are complex-valued constants. It is shown in Section [m0080_Wave_Propagation_on_a_Transmission_Line] that Equations [m0027_eV] and [m0027_eI] represent sinusoidal waves propagating in the \(+z\) and \(-z\) directions along the length of the line. The constants may represent sources, loads, or simply discontinuities in the materials and/or geometry of the line. The values of the constants are determined by boundary conditions; i.e., constraints on \(\widetilde{V}(z)\) and \(\widetilde{I}(z)\) at some position(s) along the line.

The reader is encouraged to verify that the Equations [m0027_eV] and [m0027_eI] are in fact solutions to Equations [m0027_eWaveEqnV] and [m0027_eWaveEqnI], respectively, for any values of the constants \(V_0^+\), \(V_0^-\), \(I_0^+\), and \(I_0^-\).

## Contributors

Ellingson, Steven W. (2018) Electromagnetics, Vol. 1. Blacksburg, VA: VT Publishing. https://doi.org/10.21061/electromagnetics-vol-1 Licensed with CC BY-SA 4.0 https://creativecommons.org/licenses/by-sa/4.0. Report adoption of this book here. If you are a professor reviewing, adopting, or adapting this textbook please help us understand a little more about your use by filling out this form.